Cisco Prisma II Installation And Operation Manual page 28

Forward and reverse headend driver amplifiers
Hide thumbs Also See for Prisma II:
Table of Contents

Advertisement

Installing the Module in the Chassis,
3.
Gently slide the module into the chassis until you feel the connectors on the
back of the module join the receptacles at the back of the slot.
Note: Do not force or bang the module into the chassis. If properly aligned, it
will slide in with minimal force.
4.
Secure the module by pressing the two ejectors located on the left side of the
module until they lock. When the levers are locked, the power and
communications connections at the rear of the module mates with the
communications connectors at the back of the chassis slot.
5.
Hand-tighten the screw at the top of the module, to secure it in the chassis.
Use a
2-8
/
-in. flat-blade screwdriver to secure. Do not over tighten.
3
8
Installation
Continued
78-4006323-01 Rev C

Advertisement

Table of Contents
loading

Table of Contents