Ethernet Cradle/ Usb Cradle - Casio DT-X8-20C-CNV Hardware Manual

DT-X200 Hardware Manual

3.1.2. Ethernet Cradle/ USB Cradle

Item
Interface to DT-X200
LAN
(Only Ethernet Cradle)
USB Host
USB Client
Input from AC Adaptor
(Ethernet Cradle)
Input from AC Adaptor
(USB Cradle)
＊1
Pin Layout
The pin layout below shows when the cradle is viewed at its front.
Pin Layout and the description
Pin no. Signal
1 V CRADLE
2 D +
3 D -
4 USB_ID
5 V BUS
6 GND
Notes:
1. The output is made from the cradle. The direction "OUT" is for USB mode, or "IN" for LAN mode.
Type Contact Connector
Baud rate Full speed (12Mbps)
Protocol IEEE 802.3 Standard
Connector
USB connector A type
Baud rate Full speed (12Mbps)
Power to external
5V±5%, 500 mA (maximum)
device
Connector
USB connector B type
Baud rate Full speed (12Mbps)
Input voltage DC 12V±5％
Adaptor AD-S42120C
Input voltage DC 5V±5％
Adaptor AD-S15050B
Description
Power supply to the terminal and charge to
battery pack installed in the terminal.
USB D +
USB D -
Switch-over between USB host and USB
client
Power from/to USB cradle
GND
CASIO COMPUTER CO., LTD.
Specification
Communicate and power supply
to DT-X200
Refer ＊１
1 VBus
1 2 3 4
2 USB D-
3 USB D+
4 GND
Low speed not supported
1
2
1 VBus
2 USB D-
3 USB D+
3 4
4 GND
Low speed not supported
P.18
Remark
Direction
-
IN/OUT
IN/OUT
OUT (Note 1)
-
-