Ec Declaration Of Conformity; General Power Tool Safety Warnings - Makita DSP600 Instruction Manual

EC Declaration of Conformity

For European countries only
to this instruction manual.
SAFETY WARNINGS

General power tool safety warnings

WARNING:
Read all safety warnings, instruc-
with this power tool. Failure to follow all instructions
tions for future reference.
Work area safety
1. Keep work area clean and well lit. Cluttered or
dark areas invite accidents.
2.
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
3. Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.
Electrical Safety
1.
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools.
reduce risk of electric shock.
2.
surfaces, such as pipes, radiators, ranges and
refrigerators.
tric shock if your body is earthed or grounded.
3. Do not expose power tools to rain or wet con-
ditions. Water entering a power tool will increase
the risk of electric shock.
4.
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges
increase the risk of electric shock.
5. When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of
a cord suitable for outdoor use reduces the risk of
electric shock.
6. If operating a power tool in a damp location
(RCD) protected supply. Use of an RCD reduces
the risk of electric shock.
Damaged or entangled cords
7. Power tools can produce electromagnetic
However, users of pacemakers and other similar
medical devices should contact the maker of their
this power tool.
Personal Safety
1. Stay alert, watch what you are doing and use
common sense when operating a power tool.
Do not use a power tool while you are tired or
ication.
2.
wear eye protection.
as a dust mask, non-skid safety shoes, hard hat or
hearing protection used for appropriate conditions
3.
switch is in the off-position before connecting
-
to power source and/or battery pack, picking
up or carrying the tool. Carrying power tools with
that have the switch on invites accidents.
4.
turning the power tool on.
attached to a rotating part of the power tool may
5.
-
balance at all times.
of the power tool in unexpected situations.
6. Dress properly. Do not wear loose clothing or
long hair can be caught in moving parts.
7.
dust extraction and collection facilities, ensure
these are connected and properly used. Use of
dust collection can reduce dust-related hazards.
8. Do not let familiarity gained from frequent use
of tools allow you to become complacent and
ignore tool safety principles.
-
The goggles must comply with ANSI Z87.1 in
the USA, EN 166 in Europe, or AS/NZS 1336
in Australia/New Zealand. In Australia/New
Zealand, it is legally required to wear a face
shield to protect your face, too.
3 ENGLISH
-