Maintenance - Makita DSP600 Instruction Manual

State of abnormality
along with the switch operation of
the tool.
tool's switch trigger is not pulled.

MAINTENANCE

CAUTION:
Always be sure that the tool is
before attempting to perform inspection or
maintenance.
CAUTION:
Clean out the guard to ensure
there is no accumulated sawdust which may
impede the operation of the guarding system.
dirty guarding system may limit the proper operation
most effective way to accomplish this cleaning is with
compressed air. If the dust is being blown out of
the guard, be sure the proper eye and breathing
protection is used.
NOTICE:
alcohol or the like. Discoloration, deformation or
cracks may result.
Probable cause (malfunction)
the tool.
into the tool.
the slot is dirty.
tool has not been pushed.
More than 10 tools are registered to the
vacuum cleaner.
registrations.
No power supply
Radio disturbance by other appliances
which generate high-intensity radio
waves.
Other users are using the wireless
activation of the vacuum cleaner with
their tools.
22 ENGLISH
Remedy
Install the wireless unit correctly.
Gently wipe off dust and dirt on the terminal of the
wireless unit and clean the slot.
sure that the wireless activation lamp is blinking
in blue.
Set the stand-by switch on the vacuum cleaner to
Perform the tool registration again.
If more than 10 tools are registered to the vacuum
cleaner, the tool registered earliest will be cancelled
automatically.
Perform the tool registration again.
Supply the power to the tool and the vacuum
cleaner.
Get the tool and vacuum cleaner closer each other.
mately 10 m however it may vary according to the
circumstances.
appliances such as Wi-Fi devices and microwave
ovens.
tools or cancel the tool registration of the other
tools.
accuracy
NOTICE:
NOTICE:
procedures.
1. Slightly loosen the clamping screws on the front
and rear of the tool.
2.
-