Guide Rail; Operation - Makita DSP600 Instruction Manual

Optional accessory
When you wish to perform clean cutting operation,
connect a Makita vacuum cleaner to your tool. Connect
a hose of the vacuum cleaner to the dust nozzle using
the front cuff 24.
1. Hose of the vacuum cleaner 2. Front cuff 24
3. Dust nozzle

OPERATION

CAUTION:
in a straight line gently. Forcing or twisting the tool
will result in overheating the motor and dangerous
CAUTION:
body under the tool base when section cutting,
especially at starting. Doing so may cause seri-
the tool base.
NOTE: When the battery cartridge temperature is
time, for example, use the tool for a light-duty cut for
a while until the battery cartridge warms up as high
full capacity.
Section cutting (ordinary sawing)
1 2
3
grip and rear handle. Use both to best grasp the tool.
If both hands are holding saw, they cannot be cut by
the circular saw blade. Set the base on the workpiece
to be cut without the circular saw blade making any
switch trigger. Wait until the circular saw blade attains
full speed. Now press down the saw head slowly to the
preset depth of cut and simply move the tool forward
ing smoothly until the sawing is completed.
your speed of advance uniform. If the cut fails to prop-
erly follow your intended cut line, do not attempt to turn
or force the tool back to the cut line. Doing so may bind
the circular saw blade and lead to dangerous kickback
for the circular saw blade to stop and then withdraw
the tool. Realign the tool on new cut line, and start

Guide rail

Optional accessory
smoothly without a clatter. Hold both the front grip and
down the tool to the preset cutting depth and cut the
splinterguard along the full length with a stroke. Now
the edge of the splinterguard corresponds to the cutting
edge.
1.
When bevel cutting with the guide rail, use the slide
lever to prevent the tool from falling over.
Move the slide lever on the tool base in the direction
of arrow so that it engages the undercut groove in the
guide rail.
14 ENGLISH
-
1