Makita DSP600 Instruction Manual page 10

1
1. Blade lower limit stopper 2. Clamping screw
Quick stop button for 2 to 3 mm
depth of cut when using guide rail
(optional accessory)
of cut on the gear housing aside the rear handle when
the workpiece in the cut. Make a pass of the 2 to 3 mm
1
1. Quick stop button
avoiding splinter on the workpiece.
Loosen the clamping screws. Set for the desired angle by
tilting accordingly, then tighten the clamping screws securely.
2
1. Clamping screw 2. Bevel scale plate
1
1.
blade until it stops and secure the base with the clamping screws.
1. Positive stopper 2. Clamping screw
10 ENGLISH
1
2
2. Clamping screw
1
1
2
2
2