Table of Contents
Advertisement
Chapter 3
Maintaining the Cisco 10005 ESR
Step 5
Warning
Step 6
Step 7
Replacing an AC Power Supply
Warning
OL-1102-07
Snug up the strain relief device the secures the power cord to the power supply.
To do this, tighten the screw underneath the power connector
Figure 3-7
Tightening AC Power Cord Strain Relief
Do not over-tighten the strain relief devices that secure the power cords to the
power supplies. Because this chassis cannot be switched off completely, you
must disconnect the power cords to remove power from the chassis. The power
cord serves as the primary disconnect in an emergency.
Plug the AC input power cord into a power receptacle.
Set the power switch on the new power supply to the | (on) position.
The green LED on the PEM lights up, indicating that the power supply is on.
Never install an AC power module and a DC power module in the same chassis.
To replace an AC power supply:
Cisco 10005 ESR Hardware Overview and Maintenance Guide
Removing and Replacing Field-Replaceable Units
IO N
P O W E
C A U T
IO N
R
C A U T
P O W E
N O N E
N O N E
E T H A
)
A
C
E T H A
W O (2
)
T I
U
A
C
W O (2
O
U
S M O R
E C T T
N
O
T I
S M O R
E C T T
N
N IT H A
C O N N
N IT H A
C O N N
R E
B E F O
R E
C K .
T H IS U
R D . D IS
R D . D IS
B E F O
C K .
T H IS U
IC S H O
O R D S
IC S H O
LY C O
LY C O
O R D S
L E C T R
S U P P
P LY C
P LY C
LE C T R
S U P P
R S U P
R S U P
O ID E
O ID E
P O W E
P O W E
T O A V
TO A V
IC IN G
IC IN G
S E R V
S E R V
(Figure
3-7).
R
3-15
Advertisement
Table of Contents
