Removing And Replacing The Ac Power Supply - Cisco ASR 903 Installing Manual

Installing the Cisco ASR 903 Router

Removing and Replacing the AC Power Supply

This section describes how to remove and replace the AC power supply.
The Cisco ASR 903 Router power supplies are hot-swappable. If you have installed redundant power
Note
supply modules, you can replace a single power supply without interrupting power to the router.
To avoid erroneous failure messages, allow at least 2 minutes for the system to reinitialize after a power
Caution
supply has been removed or replaced.
When you install the unit, the ground connection must always be made first and disconnected last. Statement
Warning
1046
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Warning
Statement 1003
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
Follow these steps to remove and replace the AC power supply:
Step 1
Disconnect the power cord from the power source. Do not touch the metal prongs on the power cord when it is still
connected to the power supply.
Step 2 Remove the power cord from the power connection on the power supply. Do not touch the metal prongs embedded in
the power supply.
Step 3 Loosen the captive installation screws.
Step 4 Grasp the AC power supply with one hand, and slide it part of the way out of the chassis. Place your other hand underneath
the power supply, and slide it completely out of the chassis.
Step 5 If the power supply bay is to remain empty, install a blank filler plate (Cisco part number A900-PWR-BLANK) over
the opening, and secure it with the captive installation screws.
Cisco ASR 903 and ASR 903U Aggregation Services Router Hardware Installation Guide
Removing and Replacing the AC Power Supply
43