Cisco 10005 ESR Manual page 23

Chapter 3 Maintaining the Cisco 10005 ESR
Step 5
Figure 3-13 Removing and Replacing the Line Card
Step 6
Warning
Step 7
Step 8
OL-1102-07
Slide the line card out of the slot
or in an antistatic bag.
OC -12
/ST M- 4
OC -12
/ST M- 4
6X CT 3–
DS 0
6X CT 3– 6X CT 3–
DS 0 DS 0
OC -12
GIG AB /ST M- 4
IT ET HE
If you do not plan to immediately install a new line card, install a blank faceplate
over the empty line card slot.
Blank faceplates (filler panels) serve three important functions: they prevent
exposure to hazardous voltages and currents inside the chassis; they contain
electromagnetic interference (EMI) that might disrupt other equipment; and
they direct the flow of cooling air through the chassis. Do not operate the
system unless all cards, power modules, and faceplates are in place.
Grasp the faceplate of the new line card with one hand and place your other hand
under the card carrier (to support the weight of the card). Position the card in front
of the card cage slot.
Carefully align the left and right edges of the line card with the guides in the
chassis and slide the line card into the slot until you can feel it begin to mate with
the midplane connectors.
Cisco 10005 ESR Hardware Overview and Maintenance Guide
Removing and Replacing Field-Replaceable Units
(Figure 3-13) and place it on an antistatic surface
PO S SM
-IR
PO S SM
-IR
AT M SM
RN ET
-IR
3-23