Makita ST113D Instruction Manual page 8

You can operate the tool in either way of "single
Single sequential actuation:
tial operation.
1.
2. Hold both of the front part and the rear part of the
3.
4.
move the contact element from the material.
Contact actuation:
1.
2.
tact element on the material to drive the staples.
3.
contact element on the material again.
NOTE:
driven.
1. Groove
If the head of the staple remains above the workpiece
surface, drive the staple while holding the stapler head
NOTE: If the head of the staple still remains above
the workpiece even you hold the stapler head,
the material may not be suitable for the stapler.
Continuing to use the stapler on such material may
-
-
1
8 ENGLISH
WARNING:
When loading staples, always
make sure that the battery cartridge is removed
from the stapler.
When the number of remaining staples in the magazine
becomes 5 - 8 pieces, the switch trigger can no longer
be pulled. At this time, insert a new strip of staples in the
Checking remaining staples
1
1. Sight window 2.
Remaining staples can be checked through the sight
window.
Reload staples when no remaining staples can be seen
in the sight window.
Removing jammed staples
WARNING:
Always make sure that the battery
cartridge is removed before removing jammed
staples.
1
1. Opening 2. Sub magazine
2
3
3. Staples
2