Cisco TelePresence DX70 and DX80
Introduction
Standby configuration
xConfiguration Standby Control
Define whether the system should go into standby mode or not.
Requires user role: ADMIN, INTEGRATOR
Default value: On
USAGE:
xConfiguration Standby Control:
where
Control
: Off/On
Off: The system will not enter standby mode.
On: The system will enter standby mode when the Standby Delay has timed out.
Requires the Standby Delay to be set to an appropriate value.
xConfiguration Standby Delay
Define how long (in minutes) the system shall be in idle mode before it goes into standby mode.
Requires the Standby Control to be enabled.
Requires user role: ADMIN, INTEGRATOR
Default value: 10
USAGE:
xConfiguration Standby Delay:
Delay
where
Delay
: Integer (1..480)
Set the standby delay (minutes).
D15363.05 Cisco TelePresence DX70 and DX80 API Reference Guide CE9.2, NOVEMBER 2017.
About the API
xConfiguration
xConfiguration
Control
xCommand
xConfiguration Standby WakeupOnMotionDetection
Automatic wake up on motion detection is a feature that will sense when a person walks into
the room. The feature is based on ultrasound detection, and the Proximity Mode setting must
be On to make the feature work.
Requires user role: ADMIN, INTEGRATOR
Default value: Off
USAGE:
xConfiguration Standby WakeupOnMotionDetection:
where
WakeupOnMotionDetection
: Off/On
Off: The wake up on motion detection is disabled.
On: When people walk into the room the system will automatically wake up from
standby (only applicable to DX80).
76
API Reference Guide
xStatus
Appendices
WakeupOnMotionDetection
Copyright © 2017 Cisco Systems, Inc. All rights reserved.