Dos And Don'ts - Cisco TelePresence DX70 Reference Manual

Cisco TelePresence DX70 and DX80

Introduction

Dos and don'ts

Here are some best practices when programming the Cisco
series API.
DO use complete commands
You should always use complete commands when
programming, i.e. always use xConfiguration Video instead of
xconf vid. The shortcuts can be used for searches in the API
on the command line, but not for programming. The reason
for this is that you might end up with ambiguous code when
additional commands are added to the API.
DO NOT subscribe to unnecessary feedback
Subscribing to too much feedback may congest the control
application. Although the amount of feedback may seem fine
in the current version, the amount of feedback may grow in
future releases.
D15363.05 Cisco TelePresence DX70 and DX80 API Reference Guide CE9.2, NOVEMBER 2017.
About the API About the API xConfiguration xCommand
37
API Reference Guide
xStatus Appendices
Copyright © 2017 Cisco Systems, Inc. All rights reserved.