Installation - GE L90 Instruction Manual

5 SETTINGS
An example user display setup and result is shown below:
USER DISPLAY 1
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
USER DISPLAYS
PATH: SETTINGS PRODUCT SETUP

INSTALLATION

MESSAGE
To safeguard against the installation of a relay without any entered settings, the unit will not allow signaling of any output
relay until is set to "Programmed". This setting is defaulted to "Not Programmed" when at the factory. The
RELAY SETTINGS
self-test error message is displayed until the relay is put into the "Programmed" state.
UNIT NOT PROGRAMMED
The setting allows the user to uniquely identify a relay. This name will appear on generated reports. This name
RELAY NAME
is also used to identify specific devices which are engaged in automatically sending/receiving data over the Ethernet com-
munications channel using the IEC 61850 protocol.
GE Multilin
DISP 1 TOP LINE:
Current X ~
DISP 1 BOTTOM LINE:
Current Y ~
DISP 1 ITEM 1:
6016
DISP 1 ITEM 2:
6357
DISP 1 ITEM 3:
0
DISP 1 ITEM 4:
0
DISP 1 ITEM 5:
0
Current X 0.850 A
→
Current Y 0.327 A
INSTALLATION
RELAY SETTINGS:
Not Programmed
RELAY NAME:
Relay-1
L90 Line Current Differential System
Shows user-defined text with first Tilde marker.
A
Shows user-defined text with second Tilde marker.
A
Shows decimal form of user-selected Modbus Register
Address, corresponding to first Tilde marker.
Shows decimal form of user-selected Modbus
Register Address, corresponding to 2nd Tilde marker.
This item is not being used - there is no corresponding
Tilde marker in Top or Bottom lines.
This item is not being used - there is no corresponding
Tilde marker in Top or Bottom lines.
This item is not being used - there is no corresponding
Tilde marker in Top or Bottom lines.
Shows the resultant display content.
Range: Not Programmed, Programmed
Range: up to 20 alphanumeric characters
5.2 PRODUCT SETUP
5.2.17 INSTALLATION
5
5-57