Image Scanner Name - Honeywell 2020 User Manual

Image Scanner Name

You may assign a name to each image scanner you are using. When you have
multiple image scanners linked to one base, you may want to name each image
scanner so you will be able to control the image scanner receiving imaging
commands sent from the base.
The default name for a 4820 is "4820," and "4820i" for a 4820i. If you have more
than one image scanner linked to a base, and they all have the default names,
the first image scanner linked to the base receives commands. You can change
the name of an image scanner using a serial command (refer to "Image Scanner
Name" on page 5-8) or using a barcode command. To change the name
serially, unlink all except one of the image scanners from the base. Send
":4820:BT_NAM name ." or ":4820i:BT_NAM name .", where name is the new
image scanner name. If you wish to change the names of additional image
scanners, re-link them one at a time and repeat the ":4820:BT_NAM name ." or
":4820i:BT_NAM name ." command for each image scanner.
3 - 8 2020 User's Guide