Advertisement
WM821-M MiniPCI Module
IMPORTANT NOTE:
This module is intended for OEM integrator only and limited to host with brand: HP and model: Medi-
aSmart Connect x280n.
of the end product, which integrates this module.
USERS MANUAL OF THE END PRODUCT:
In the users manual of the end product, the end user has to be informed to keep at least 20cm sepa-
ration with the antenna while this end product is installed and operated. The end user has to be
informed that the FCC radio-frequency exposure guidelines for an uncontrolled environment can be
satisfied. The end user has to also be informed that any changes or modifications not expressly ap-
proved by the manufacturer could void the user's authority to operate this equipment.
The FCC part 15.19 statement below has to also be available in the manual:
This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference and (2) this device must accept any interference
received, including interference that may cause undesired operation.
LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following "
".
WM821MHP
The OEM integrator has to be aware not to provide information to the end user regard-
ing how to install or remove this RF module in the user's manual of the end product
which integrates this module.
The end user manual shall include all required regulatory information/warning as show in this manual.
ii
The OEM integrator is still responsible for the FCC compliance requirement
Manual Information To the End User
—Introduction
Contains TX FCC ID:
N89-
Advertisement
