Cisco Mds 9000 Family Nx-Os Fundamentals Configuration Guide - Cisco MDS 9000 Series Configuration Manual

Hide thumbs Also See for MDS 9000 Series:
Table of Contents

Advertisement

Configuring Out-of-Band Management
Step 22
Enter permit (deny is the default) to deny a default zone policy configuration.
Configure default zone policy (permit/deny) [deny]: permit
Permits traffic flow to all members of the default zone.
Note
If you are executing the setup script after issuing a write erase command, you must explicitly change the default
zone policy to permit for VSAN 1 after finishing the script using the following commands:
switch# configure terminal
switch(config)# zone default-zone permit vsan 1
Step 23
Enter yes (no is the default) to disable a full zone set distribution.
Enable full zoneset distribution (yes/no) [n]: yes
Overrides the switch-wide default for the full zone set distribution feature.
You see the new configuration. Review and edit the configuration that you have just entered.
If you are executing the setup script after issuing a write erase command, you must explicitly change the default
Note
zone policy to permit for VSAN 1 after finishing the script using the following commands:
switch# configure terminal
switch(config)# zoneset distribute full vsan 1
Step 24
Enter enhanced (basic is the default) to configure default-zone mode as enhanced.
Configure default zone mode (basic/enhanced) [basic]: enhanced
Overrides the switch-wide default zone mode as enhanced.
If you are executing the setup script after issuing a write erase command, you must explicitly change the default
Note
zoning mode to enhanced for VSAN 1 after finishing the script using the following commands:
switch# configure terminal
switch(config)# zone mode enhanced vsan 1
Step 25
Enter no (no is the default) if you are satisfied with the configuration.
The following configuration will be applied:
username admin password admin_pass role network-admin
username user_name password user_pass role network-admin
snmp-server community snmp_community ro
switchname switch
interface mgmt0
ip address ip_address subnet_mask
no shutdown
ip routing
ip route dest_prefix dest_mask dest_address
ip default-network dest_prefix
ip default-gateway default_gateway
ip name-server name_server
ip domain-name domain_name

Cisco MDS 9000 Family NX-OS Fundamentals Configuration Guide

18
Using the Cisco NX-OS Setup Utility
OL-29291-02

Advertisement

Table of Contents
loading

Table of Contents