Cisco Mds 9000 Family Nx-Os Fundamentals Configuration Guide - Cisco MDS 9000 Series Configuration Manual

Configuring Out-of-Band Management
c) Enter yes (yes is the default) to configure a static route.
Configure static route: (yes/no) [y]: yes
Enter the destination prefix.
Destination prefix: dest_prefix
Enter the destination prefix mask.
Destination prefix mask: dest_mask
Enter the next hop IP address.
Next hop ip address: next_hop_address
Be sure to configure the IP route, the default network IP address, and the default gateway IP address to
Note
enable SNMP access. If IP routing is enabled, the switch uses the IP route and the default network IP address.
If IP routing is disabled, the switch uses the default gateway IP address.
d) Enter yes (yes is the default) to configure the default network.
Configure the default-network: (yes/no) [y]: yes
Enter the default network IPv4 address.
Note The default network IPv4 address is the destination prefix provided in Step
10c.
Default network IP address [dest_prefix]: dest_prefix
e) Enter yes (yes is the default) to configure the DNS IPv4 address.
Configure the DNS IP address? (yes/no) [y]: yes
Enter the DNS IP address.
DNS IP address: name_server
f) Enter yes (no is the default) to skip the default domain name configuration.
Configure the default domain name? (yes/no) [n]: yes
Enter the default domain name.
Default domain name: domain_name
Step 11
Enter yes (yes is the default) to enable the SSH service.
Enabled SSH service? (yes/no) [n]: yes

Cisco MDS 9000 Family NX-OS Fundamentals Configuration Guide

16
Using the Cisco NX-OS Setup Utility
OL-29291-02