Table of Contents
Advertisement
Installing and Removing a SIP
This chapter describes how to install or remove SIPs on a Cisco 10000 series router. This chapter
contains the following sections:
•
•
•
Handling SIPs
Each SIP circuit board is mounted to a metal carrier and is sensitive to electrostatic discharge (ESD)
damage. Before you begin installation, read
of parts and tools required for installation.
Caution
Always handle the SIP by the carrier edges; never touch the SIP components or connector pins
(see
When a slot is not in use, a blank filler plate must be installed in the empty slot to allow the router to
conform to electromagnetic interference (EMI) emissions requirements and to allow proper airflow
across the installed modules. If you plan to install a SIP in a slot that is not in use, you must first remove
the two blank filler plates.
OL-13838-01
Handling SIPs, page 5-45
Online Insertion and Removal of a SIP, page 5-46
SIP Installation and Removal, page 5-49
Figure
5-1).
C H A P T E R
Chapter 4, "Preparing to Install a SIP or a SPA,"
Cisco 10000 Series Router SIP and SPA Hardware Installation Guide
5
for a list
5-45
Advertisement
Table of Contents
