Specifying The Location For A Spa - Cisco 10000 SIP-600 Installation Manual

10000 series router sip and spa hardware
Table of Contents

Advertisement

Chapter 2
Cisco 10000 Series Router SPA Interface Processor-600
LCMON version, slot 5/0
/vob/lcdos/obj-c10k-pq3-lcmon 114)
Operational Image version, slot 5/0
BLD-v122_34_sb_lc_throttle.lcdos-V122_33_3_10_SB-v122_34_sb_throttle
/vob/lcdos/obj-c10k-spumoni 102) major version 1219740068.
0 seconds)
subslot 5/0
For more information about SIP commands, see the Cisco 10000 Series Router SIP and SPA Software
Configuration Guide.

Specifying the Location for a SPA

A Cisco 10000 SIP-600 supports four subslots for the installation of SPAs. The SPA subslots are
numbered from 0 to 3, as shown in
numeric label on the SIP faceplate.
SPAs in the Cisco 10000 series router use an addressing format that specifies the physical location of the
SIP, SPA, and interface in the format slot/subslot/port, where:
OL-13838-02
Controller Type
Hardware Revision
PCB Part Number
Board Revision
Deviation Number
Fab Version
PCB Serial Number
RMA Test History
RMA Number
RMA History
Top Assy. Part Number
CLEI Code
Product Identifier (PID) : 10000-SIP-600
Version Identifier (VID) : V00
LCDOS (V122_33_2_31_SBK06-BOOT : DEVELOPMENT BUILD chandrav-lcmon
Built by chandrav at Sun Jun 15 13:55:54 2008.
Reset reason 0x00000008 (PRE hard reset).
LCDOS (C10000 4 SPA Jacket Card Image (Spumoni) : DEVELOPMENT BUILD
Built by richv at Tue Aug 26 04:44:51 2008.
SW Version 1.1
Code MD5 53E9196510CAE3216B1663318CA47620
FPGA MD5 89C8DD3DCD939BDD43DB19D514416137
Expected Switchover Action: NO ACTION
ECC 1 bit errors since last cleared (dd hh mm ss) = 0 (0 days, 0 hours, 0 minutes,
ECC 1 bit errors while up (total) = 0
Number of crashdumps recorded = 3
SPA Information:
SPA-2XCHOC12/DS0
SW Version 1.0
Expected Switchover Action: NO INFORMATION
Product Identifier (PID) : SPA-2XCHOC12/DS0
Version Identifier (VID) : V01
PCB Serial Number
Top Assy. Part Number
Top Assy. Revision
Hardware Revision
CLEI Code
The Transceiver in slot 5 subslot 0 port 0 is ENABLED.
The Transceiver in slot 5 subslot 0 port 1 is ENABLED.
: 1380
: 1.0
: 73-10771-01
:
: 0-0
: 01
: CSJ10497112
: 00
: 0-0-0-0
: 00
: 800-27953-01
: UNASSIGNED
ok
: PRTA6404025
: 68-3137-01
: 02
: 0.17
:
Figure
2-2. The number for each SPA subslot is indicated by a small
Cisco 10000 Series Router SIP and SPA Hardware Installation Guide
Identifying Slots and Subslots for SIPs and SPAs
2-9

Advertisement

Table of Contents
loading

Table of Contents