Honeywell XNX Quick Start Manual page 28

7. Plug the connector into the back of the mV personality board.
8. Install the mV sensor.
9. Terminate wiring at the mV sensor.
10. At the transmitter, pass the wires through the ferrite bead as shown
in Figure 16 and terminate the wiring at the pluggable terminal block
as shown in Figure 14.
In remote mount MPD configurations, the three wires from the sensor that
connect to the pluggable terminal block must be routed through the supplied
ferrite bead (part no. 0060-1051, supplied in the accessory kit), as shown in
Figure 16.
Power
Ferrite Bead
for Remote
Sensor Wiring
11. Verify point-to-point connections before completing the installation
and applying power.
12. Calibrate the sensor.
13. Reinstall the weatherproof cover on the transmitter.
Note: Environmental conditions that compromise the IP66 protection provided by
the weather proof cover will extend published response times. Safety protocols
or maintenance procedures that consider these environmental conditions are
recommended specific to the installation.
28
lnternal Ground Lug
(do not use)
mV or IR
Remote
Sensor
Figure 16. Ferrite bead wiring
XNX Universal Transmitter Quick Start Guide
XNX Universal Transmitter