Honeywell XNX Quick Start Manual page 10

WARNING
When the XNX is equipped with the optional Remote Mount Kit, the remote sensor MUST be securely
mounted to a fixed position. The Remote Sensor Kit is not intended to be used as a hand-held
detector.
The XNX is configured with 5 cable/conduit entries built into the housing
for wiring and mounting sensors. Figure 3 provides the guidelines to proper
installation of the XNX.
A
B
Figure 3. XNX Universal Transmitter cable/conduit entry assignments
10
C
MPD, 705 Series, Sensepoint Series
Searchpoint Optima Plus
Remote Sensor Connection (except EC )
Searchpoint Optima Plus - Remote
NOTE
While relay wiring can use
any available cable/conduit
E
entry in the XNX enclosure,
do not use the same cable/
conduit entry for both relay
reset and relay signal lines to
avoid electrical noise.
*
D
* Limited access due to
IS barrier if equipped with
electrochemical cell.
Option
Local HART Option
®
Catalytic Bead Sensor
Searchline Excel
Modbus
®
Relays
Foundation Fieldbus
Power
XNX Universal Transmitter Quick Start Guide
Position
B
C
C
A or E
Typically C
Any remaining
Any remaining
Any remaining
Any remaining
Any remaining
Any remaining