Xconfiguration Conference Autoanswer Delay; Xconfiguration Conference Defaultcall Protocol; Xconfiguration Conference Defaultcall Rate; Xconfiguration Conference Donotdisturb Defaulttimeout - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec

Introduction

xConfiguration Conference AutoAnswer Delay

Define how long (in seconds) an incoming call has to wait before it is answered automatically by
the system. Requires that AutoAnswer Mode is switched on.
Requires user role: ADMIN
Default value: 0
USAGE:
xConfiguration Conference AutoAnswer Delay:
where
: Integer (0..50)
Delay
The auto answer delay (seconds).

xConfiguration Conference DefaultCall Protocol

Define the Default Call Protocol to be used when placing calls from the system.
Requires user role: ADMIN
Default value: Auto
USAGE:
xConfiguration Conference DefaultCall Protocol:
where
: Auto/H320/H323/Sip/Spark
Protocol
Auto: Enables auto-selection of the call protocol based on which protocols are available.
If multiple protocols are available, the order of priority is: 1) SIP; 2) H323; 3) H320. If the
system cannot register, the auto-selection chooses H323.
H320: All calls are set up as H.320 calls (only applicable if connected to Cisco
TelePresence ISDN Link).
H323: All calls are set up as H.323 calls.
Sip: All calls are set up as SIP calls.
Spark: Reserved for Spark registered systems. Do not use.
SX20 Codec API Reference Guide CE8.3, JANUARY 2017.
D15316.05
About the API xConfiguration xConfiguration
Delay
Protocol
xCommand

xConfiguration Conference DefaultCall Rate

Define the Default Call Rate to be used when placing calls from the system.
Requires user role: ADMIN
Default value: 3072
USAGE:
xConfiguration Conference DefaultCall Rate:
where
: Integer (64..6000)
Rate
The default call rate (kbps).

xConfiguration Conference DoNotDisturb DefaultTimeout

This setting determines the default duration of a Do Not Disturb session, i.e. the period when
incoming calls are rejected and registered as missed calls. The session can be terminated
earlier by using the user interface. The default value is 60 minutes.
Requires user role: ADMIN
Default value: 60
USAGE:
xConfiguration Conference DoNotDisturb DefaultTimeout:
where
: Integer (1..1440)
DefaultTimeout
The number of minutes (maximum 1440 minutes = 24 hours) before the Do Not Disturb
session times out automatically.
60
API Reference Guide
xStatus Appendices
Rate
DefaultTimeout
Copyright © 2017 Cisco Systems, Inc. All rights reserved.