Xconfiguration Networkservices Https Server Minimumtlsversion; Networkservices Configuration; Xconfiguration Networkservices Cdp Mode; Xconfiguration Networkservices H323 Mode - Cisco TelePresence SX10 Reference Manual

Cisco TelePresence SX10

Introduction

NetworkServices configuration

xConfiguration NetworkServices CDP Mode

Enable or disable the CDP (Cisco Discovery Protocol) daemon. Enabling CDP will make the
endpoint report certain statistics and device identifiers to a CDP-enabled switch. If CDP is
disabled, the Network VLAN Voice Mode: Auto setting will not work.
Requires user role: ADMIN
Default value: On
USAGE:
xConfiguration NetworkServices CDP Mode:
where
: Off/On
Mode
Off: The CDP daemon is disabled.
On: The CDP daemon is enabled.

xConfiguration NetworkServices H323 Mode

Define whether the system should be able to place and receive H.323 calls or not.
Requires user role: ADMIN
Default value: Off
USAGE:
xConfiguration NetworkServices H323 Mode:
where
: Off/On
Mode
Off: Disable the possibility to place and receive H.323 calls.
On: Enable the possibility to place and receive H.323 calls (default).
Cisco TelePresence SX10 API Reference Guide CE9.1, JUNE 2017.
D15333.07
About the API xConfiguration xConfiguration
Mode
Mode
xCommand

xConfiguration NetworkServices HTTP Mode

Define whether or not to allow access to the video system using the HTTP or HTTPS (HTTP
Secure) protocols. Note that the video system's web interface use HTTP or HTTPS. If this
setting is switched Off, you cannot use the web interface.
If you need extra security (encryption and decryption of requests, and pages that are returned
by the web server), allow only HTTPS.
Requires user role: ADMIN
Default value: HTTP+HTTPS
USAGE:
xConfiguration NetworkServices HTTP Mode:
where
: Off/HTTP+HTTPS/HTTPS
Mode
Off: Access to the video system not allowed via HTTP or HTTPS.
HTTP+HTTPS: Access to the video system allowed via both HTTP and HTTPS.
HTTPS: Access to the video system allowed via HTTPS, but not via HTTP.

xConfiguration NetworkServices HTTPS Server MinimumTLSVersion

Set the lowest version of the TLS (Transport Layer Security) protocol that is allowed.
Requires user role: ADMIN
Default value: TLSv1.1
USAGE:
xConfiguration NetworkServices HTTPS Server MinimumTLSVersion:
where
: TLSv1.1/TLSv1.2
MinimumTLSVersion
TLSv1.1: Support of TLS version 1.1 or higher.
TLSv1.2: Support of TLS version 1.2 or higher.
55
API Reference Guide
xStatus Appendices
Mode
MinimumTLSVersion
Copyright © 2017 Cisco Systems, Inc. All rights reserved.