Serial Connection Over Micro Usb - Cisco TelePresence SX10 Reference Manual

Cisco TelePresence SX10

Introduction

Serial connection over micro USB

You can use the micro USB connector for direct communica-
tion with the video system. You may need to install a serial
port driver on your computer manually.
The serial connection can be used without an IP address,
DNS or a network. Serial connection is allowed by default.
xConfiguration SerialPort Mode: <Off/On>
Baud-rate and other serial port parameters
The serial port uses 115200 bps, 8 data bits, no parity and 1
stop bit.
Login and password
You can choose whether login is required or not for serial
connections. For security reasons the password prompting is
turned on by default, but it can be turned off if preferred.
xConfiguration SerialPort LoginRequired: <Off/On>
Cisco TelePresence SX10 API Reference Guide CE9.1, JUNE 2017.
D15333.07
About the API About the API xConfiguration
User roles
A user account may hold one or a combination of user roles.
A user account with full access rights, like the default admin
user, should possess the ADMIN, USER and AUDIT roles.
These are the user roles:
ADMIN: A user with this role can create new users, change
most settings, make calls, and search the contact lists. The
user cannot upload audit certificates and change the security
audit settings.
USER: A user with this role can make calls and search the
contact lists. The user can modify a few settings, for example
adjust the ringtone volume and set the time and date format.
AUDIT: A user with this role can change the security audit
settings and upload audit certificates.
ROOMCONTROL: A user with this role can create in-room
controls. The user has access to the In-room control editor
and corresponding developement tools.
INTEGRATOR: A user with this role has access to settings,
commands and status that are required to set up advanced
AV scenarios, and to integrate our video systems with 3rd
party equipment. Such a user can also create in-room
controls.
Cisco Spark registered systems
If a video system is registered to Cisco's cloud service
(Cisco Spark), only local users with the INTEGRATOR and
ROOMCONTROL user roles are available.
xCommand
16
API Reference Guide
xStatus Appendices
Copyright © 2017 Cisco Systems, Inc. All rights reserved.