Charge Your Phone With The Multicharger - Cisco 8821 User Manual

Accessories
Here is a close-up of the post holder.
Step 5 Plug the jack end of the power cord into the multicharger.
Step 6 Plug the other end of the power cord into the power adapter.
Step 7
Plug the power adapter into the electrical outlet.

Charge Your Phone with the Multicharger

You can tell when your phone is charging in the multicharger when the LED beside the phone lights red.
When the battery is fully charged, the LED turns off. Your phone can take up to 3 hours to recharge.
If your phone has a protective case, you don't need to remove the case before you charge the phone in the
multicharger. You adapt the multicharger to fit the phone.
When you put the phone into the multicharger, make sure that you align the charging pins on the bottom of
the phone with the connector in the multicharger. If the LED does not light, then the alignment is not correct.
Caution Do not charge the phone in a hazardous environment.
Do not charge the phone if it is wet.
Charge Your Phone with the Multicharger
Cisco Wireless IP Phone 8821 and 8821-EX User Guide
85