Cisco Wireless Ip Phone 8821 And 8821-Ex User Guide - Cisco 8821 User Manual

Phone Setup
b) Press More and select Save.
Step 8
Select Security mode.
Step 9 Select the type of security that the access point requires.
Step 10 Set the required security fields using the following table:
Security Mode
None
WEP
PSK
EAP-FAST
PEAP-GTC
PEAP-MSCHAPV2
EAP-TLS
Step 11 Select 802.11 mode and select the required mode.
The mode determines the frequency. If you set the mode to Auto, the phone can use either the 5 GHz or 2.4
GHz frequency, with 5 GHz as the preferred frequency.
Step 12 Select On call power save and press Select to change the setting.
This field should only be set to Disabled if required for troubleshooting.
Step 13 Press More and select Save.
Step 14 Press Power/End Call
Configured Field Description
- When the Security mode is set to None, no other fields
are required.
WEP key Enter the 40/104 or 64/128 ASCII or Hex WEP key.
Passphrase Enter the 8-63 ASCII or 64 Hex Passphrase.
User ID Enter the userid.
Password Enter the password
User certificate Your administrator will give you the certificate type
to select and will arrange for the certificate to be
installed on your phone.
.

Cisco Wireless IP Phone 8821 and 8821-EX User Guide

Add the Phone to the Wi-Fi Network
29