Buffalo WS5600D User Manual page 8

This display shows the status of many TeraStation settings. It also displays errors and messages when available.
7
Display Button
Switches between the different display modes. Also, if the TeraStation is beeping, press this button to stop it.
8
Factory Use Only
9
Drive Lock
Open the front panel with the key to replace hard drives or press the reset button.
10
Reset Button
To shut down and reboot the TeraStation, hold down the reset button.
11
Status LEDs
Normally, these LEDs blink green when hard drives are accessed. If a drive fails, its LED will turn red.
12
VGA Connector
You can connect a VGA monitor to this port. Connecting a monitor directly to the TeraStation is only supported for
monitoring the progress of Windows Update.
13
Boot Mode Switch
Leave the switch in the HDD position during normal operation. To recover settings, insert the recovery USB drive
into a USB 3.0 or 2.0 port, move the boot switch to the USB position, and press the power button.
14
UPS Port
Connect to a UPS.
15
USB 3.0 Port
Compatible Buffalo USB 3.0 hard drives, USB flash drives, digital cameras, and USB UPSs can be connected. USB
hubs are not supported.
16
USB 2.0 Port
Compatible Buffalo USB hard drives, USB flash drives, digital cameras, and USB UPSs can be connected. USB hubs
are not supported.
17
LAN Port 1
Use an Ethernet cable to connect this port to your network.
18
LAN Port 2
This second Ethernet port may be used for network redundancy or backup. You may connect a second TeraStation
directly to this port for backup.
19
Power Connector
Use the included power cable to connect to an UPS, surge protector, or outlet.
20
Fan
Do not block the fan.
21
Anti-Theft Security Slot
Use this slot to secure your TeraStation with a cable lock (not included).
7