NETGEAR DGN2200M User Manual page 29


To use the wireless modem router WPS button to add a WPS client:
1. Select Add a WPS Client and click
Next.
By default, the Push Button
(recommended) radio button is
selected.
2. Either click the onscreen button or
press the WPS button on the front of
the wireless modem router.
The wireless modem router tries to communicate with the client (the computer that wants
to join the network) for 2 minutes.
3. Go to the client wireless computer, and run a WPS configuration utility. Follow the utility's
instructions to click a WPS button.
4. Go back to the wireless modem router screen to check for a message.
The wireless modem router WPS screen displays a message confirming that the client
was added to the wireless network. The wireless modem router generates an SSID, and
implements WPA/WPA2 wireless security. The wireless modem router keeps these
wireless settings unless you change them, or you clear the Keep Existing Wireless
Settings check box in the WPS Settings screen.
Note the new SSID and WPA/WPA2 password for the wireless network. You can view
these settings in the Wireless Settings screen. See
on page 22.
To access the Internet from any computer connected to your wireless modem router, launch
a browser such as Microsoft Internet Explorer or Mozilla Firefox. You should see the wireless
modem router's Internet LED blink, indicating communication to the ISP.
Note: If no WPS-capable client devices are located during the 2-minute
time frame, the SSID does not change, and no security is
implemented on the wireless modem router.
N300 Wireless ADSL2+ Modem Router DGN2200Mv2
Wireless Network Configuration
29
Manually Configure Wireless Settings
WPS
button