NETGEAR DGN2200M User Manual page 25


To restrict access based on MAC addresses:
1. Select Setup > Wireless Settings and click the Set Up Access List button to display
the list.
2. Select the Turn Access Control On check box to enable the restricting of wireless
computers by their MAC addresses.
Note: If you are using a wireless connection, do not click Apply until you
have added your computer's MAC address in this screen.
3. Use the Add button to add wireless stations so that they will have access.
• You can select currently connected wireless computers from the Available Wireless
Cards List.
• You can type in the MAC address for the wireless computer or device. The MAC
address is usually printed on the wireless card, or on the label of a wireless device. It
might appear in the wireless modem router's DHCP table. The MAC address is 12
hexadecimal digits.
• You can copy and paste the MAC addresses from the wireless modem router's
Attached Devices screen into the MAC Address field of this screen. To do this,
configure each wireless computer to obtain a wireless link to the wireless modem
router. The computer should then appear in the Attached Devices screen.
4. Click Add to add each entry. You can add several stations to the list.
5. When you are finished adding stations, click Apply.
Now, only computers and devices on this list can wirelessly connect to the wireless modem
router. This prevents unauthorized access to your network.
N300 Wireless ADSL2+ Modem Router DGN2200Mv2
Wireless Network Configuration
25