Show Command - Cisco Catalyst 4500 Series Software Configuration Manual

Chapter 56 Configuring Auto Security
switchport mode trunk
auto security-port uplink
end
Switch# conf t
Enter configuration commands, one per line.
Switch(config)# int g1/0/15
Switch(config-if)# no auto security-port
Switch(config-if)# end
Switch# show run int g1/0/15
Building configuration...
Current configuration : 110 bytes
!
interface GigabitEthernet1/0/15
switchport trunk encapsulation dot1q
switchport mode trunk
end

show command

Use the show auto security command, verify the status of auto-security on the interface and global level.
Use the show auto security [configuration] command, to view the CLIs that are applied with AS.
This example shows the output of the show auto security command when AS is enabled:
Switch# show auto security
Auto Security is Enabled globally
AutoSecurity is Enabled on below interface(s):
--------------------------------------------
GigabitEthernet2/0/2
GigabitEthernet2/0/3
GigabitEthernet2/0/4
GigabitEthernet2/0/5
GigabitEthernet2/0/6
GigabitEthernet2/0/7
GigabitEthernet2/0/8
GigabitEthernet2/0/9
This example shows the output of the show auto security configuration command when AS is enabled:
Switch# show auto security configuration
%AutoSecurity provides a single CLI config 'auto security'
to enable Base-line security Features like
DHCP snooping, ARP inspection and Port-Security
Auto Security CLIs applied globally:
-----------------------------------
ip dhcp snooping
ip dhcp snooping vlan 2-1005
no ip dhcp snooping information option
ip arp inspection vlan 2-1005
ip arp inspection validate src-mac dst-mac ip
Auto Security CLIs applied on Access Port:
------------------------------------------
switchport port-security
switchport port-security maximum 2
switchport port-security maximum vlan access 1
switchport port-security maximum vlan voice 1
switchport port-security violation restrict
switchport port-security aging time 2
switchport port-security aging type inactivity
ip arp inspection limit rate 100
ip dhcp snooping limit rate 100
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
End with CNTL/Z.
Configuring Auto Security
56-5