Sony DVS-9000 User Manual page 180

With ccp-8000 series center control panel

Hide thumbs Also See for DVS-9000:

Table of Contents

In the bus fixed mode there is a fixed relationship between the position of the

fader lever and the signal output on each bus. Depending on the direction of the

transition, the fader lever must therefore always be moved in a particular

direction, as shown in the following table. This does not affect an auto

transition, which is executed regardless of the fader lever direction.

Next transition

Keys 1, 2, 3, and 4

• When a transition applies to a combination of more than one of the

• If as a result of an auto transition, for example, the fader lever position does

Executing a Transition

Flip-flop mode and bus fixed mode

Fader lever operating direction in bus fixed mode

Transition direction

On t Off (deletion)

Off t On (insertion)

background and keys 1, 2, 3, and 4, then the transition for all of these must

be in the same direction complying with the above table.

not agree with the signal output, this is a non-sync state (see page 178) and

LEDs light at both end positions of the fader lever travel. Moving the fader

lever does not carry out a transition, but when the fader lever reaches the end

position the non-sync state is released, and it is now possible to carry out the

next transition. If the fader lever is moved in the direction away from the lit

LEDs, this carries out the next transition, over the remaining part of the fader

lever travel.

Flip-flop mode

Bus fixed mode

Fader lever movement