Standard Installation Of The Chassis - Cisco ASR 5000 series Installation And Administration Manual

Chassis Installation
Step c
of the chassis. Place it to the side for re-installation later.
Step d
lower-right side of the chassis.
Step 4
Proceed to either the Standard Installation of the Chassis or Mid-Mount Installation of the Chassis section that follows,
based on the mounting option you are using.

Standard Installation of the Chassis

Follow the instructions below to perform the standard installation of the chassis.
ESD C
AUTION
avoid ESD damage to the components. Failure to do so could result in damage to electrical components and could
potentially void your warranty.
Step 1
Position the chassis in the equipment rack so that the flanges of the mounting brackets at the front of the chassis are
flush with the mounting rails of the equipment rack.
Step 2
Mount the chassis to the rails of the equipment rack. Use the hardware that was supplied with the equipment rack. Begin
with the two bottom holes and work your way up until all four holes on each flange are secured.
Step 3
Repeat step 1 and step 2 for any additional chassis you are installing in the equipment rack.
Step 4 If you took steps to reduce the weight of the chassis prior to installation, refer to the instructions in the Re-Installing
Chassis Sub-components section to re-install the components. Otherwise, proceed to Application Card Installation.
OL-24878-01
Grasp the handle on the PFU and gently pull the PFU toward you. The PFU should slide easily out
Repeat step b and step c for the PFU located in the bay labeled Power Filter Unit 2 located on the
:
During installation, maintenance, and/or removal, wear grounding wrist and/or heel straps to
Cisco ASR 5000 Series Aggregation Services Router Installation and Administration Guide ▄
Installing the Chassis ▀