Mid-Mount Installation Of The Chassis - Cisco ASR 5000 series Installation And Administration Manual

▀ Installing the Chassis

Mid-Mount Installation of the Chassis

Follow the instructions below to perform the mid-mount installation of the system.
ESD C
AUTION
damage to the components. Failure to do so could result in damage to electrical components and could potentially void
your warranty.
Step 1
On the side of the chassis, unfasten the eight #2 Phillips screws that secure the mounting bracket to the chassis.
Step 2
Place the mounting bracket over the middle set of mounting holes on the side of the chassis and secure it to the chassis
with the screws you removed in step 1.
Step 3
Repeat step 1 and step 2 for the bracket on the opposite side of the chassis.
Step 4
Position the chassis in the equipment rack so that the flanges of the mounting brackets are flush with the mounting rails
of the equipment rack.
Step 5 Mount the chassis to the rails of the equipment rack with the hardware that was supplied with the equipment rack. Begin
with the two bottom holes and work your way up until all seven holes on each flange are secured.
▄ Cisco ASR 5000 Series Aggregation Services Router Installation and Administration Guide
:
During installation, maintenance, and/or removal, wear grounding wrist straps to avoid ESD
Chassis Installation
OL-24878-01