NEC univerge SV9100 Programming Manual page 655

Hide thumbs Also See for univerge SV9100:
Table of Contents

Advertisement

Issue 4.0
To have Unscreened Transfer call a specific extension, the corresponding Number option should
be that extension number. The caller then dials that single digit to reach the extension.
For example, to have callers dial 8 to reach extension 303, for key 8 enter UTRF for the Action
and 303 for the corresponding Number.
REC1 Action – Quick Message With Greeting (3) (REC1)
Use this action to allow an Automated Attendant caller to leave a Quick Message at an extension.
With this action, the caller hears the extension greeting prior to leaving the message.
Number Options
To have the caller leave a quick Message at a specific extension, the corresponding Number
option should be the extension number.
To have the caller leave a Quick Message at any caller-dialed extension, the corresponding
Number option should be IXXX.
To have the caller leave a Quick Message at a caller-dialed extension in a specific range, the
corresponding Number option should be XXX.
For example, to allow callers to leave a Quick Message extensions 301~399, for key 3 enter
REC1 for the Action and XXX for the corresponding Number.
REC2 Action – Quick Message Without Greeting (4) (REC2)
Use this action to allow an Automated Attendant caller to leave a Quick Message at an extension.
With this action, the caller does not hear the extension greeting prior to leaving the message.
Instead, the caller hears the voice prompt Recording followed by a beep.
Number Option
To have the caller leave a quick Message at a specific extension, the corresponding Number
option should be the extension number.
To have the caller leave a Quick Message at any caller-dialed extension, the corresponding
Number option should be IXXX.
To have the caller leave a Quick Message at a caller-dialed extension in a specific range, the
corresponding Number option should be XXX.
For example, to allow callers to leave a Quick Message extensions 301~399, for key 3 enter
REC2 for the Action and XXX for the corresponding Number.
LOGON Action – Log Onto Voice Mail (5) (LOGON
Use this key action to allow an Automated Attendant caller to log onto Voice Mail. Depending on
programming (see Number Option below), the caller is logged directly into a Subscriber Mailbox or
is prompted to enter a Subscriber Mailbox of their own choosing. You cannot use the LOGON
option with Call Routing and Announcement Mailboxes.
SV9100 Programming Manual
)
2-615

Advertisement

Table of Contents
loading

Table of Contents

Save PDF