Table 1-3 Keys For Entering Names - NEC univerge SV9100 Programming Manual

Hide thumbs Also See for univerge SV9100:
Table of Contents

Advertisement

S
6
P
ECTION
ROGRAMMING
Several programs (e.g., Program 20-16 : Selectable Display Messages) require you
to enter text. Use the following chart when entering and editing text. When using the
keypad digits, press the key once for the first character, twice for the second
character, etc. For example, to enter a C, press the key 2 three times. Press the key
six times to display the lower case letter. The name can be up to 12 digits long.
Use this keypad digit . . . When you want to. . .
1-6
N
AMES AND

Table 1-3 Keys for Entering Names

1
Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
2
Enter characters: A-C, a-c, 2.
3
Enter characters: D-F, d-f, 3.
4
Enter characters: G-I, g-i, 4.
5
Enter characters: J-L, j-l, 5.
6
Enter characters: M-O, m-o, 6.
7
Enter characters: P-S, p-s, 7.
8
Enter characters: T-V, t-v, 8.
9
Enter characters: W-Z, w-z, 9.
0
Enter characters:
0 ! " # $
Enter characters:
+
#
# = Accepts an entry (only required if two letters on the same key
are needed – ex: TOM). Pressing
programming mode, use the right arrow Softkey instead to accept
and/or add a space.)
Conf
Clear the character entry one character at a time.
Clear all the entries from the point of the flashing cursor and to the
Hold
right.
T
M
EXT
ESSAGES
 
%
&
'
(
,
-
.
/
:
;
<
=
Issue 4.0
Á À Â Ã Ç É Ê ì ó

) ô Õ ú ä ö ü
>
? π Σ
# again = Space. (In system
Introduction
¢ £

Advertisement

Table of Contents
loading

Table of Contents

Save PDF