Aiming Beam; Information For Developers; Custom Profiles - Honeywell Dolphin 75E User Manual

Aiming Beam

The terminal projects an aiming beam that should be centered over the bar code, but it can be positioned in any direction
for a good read. The aiming beam is smaller when the scanner is closer to the code and larger when it is farther from the
code. Hold the scanner close to smaller bar codes, and farther away from large bar codes to get a proper read. If the bar
code is highly reflective (e.g., laminated), you may need to tilt the scanner at an angle so the bar code can be scanned.
Linear Bar Code.
2D Matrix Symbol

Information for Developers

You may need to create customized profiles to configure the scanner for your application. Some settings are only possible when
using customized profiles.

Custom Profiles

Profiles are used to enable symbologies, configure symbology options, and set scanning options. The
HoneywellDecoderSettingsV2.exm file is used to define or specify one or more profiles and must be placed on the terminal
in either of these two locations:
• \Documents\Profile
The user must create the Profile folder. To learn how to transfer files from your computer to the terminal, see
the Terminal to a Computer (PC) via a USB Connection
• \SharedData\Enterprise\Persistent\Profile
This folder is only accessible by an Enterprise signed application.
Note: To download a sample HoneywellDecoderSettingsV2.exm file, go to www.honeywellaidc.com, navigate to the 75e
product page, and then select "Honeywell Decoder Settings Sample EXM File" under the Software listings.
When the HoneywellDecoderSettingsV2.exm file is updated the 75e receives notification, performs initial processing of the
profile information, and writes status information to the HoneywellDecoderSettingsV2.err file. The err file is written back to
the same location as the exm file, either \Documents\Profile or \SharedData\Enterprise\Persistent\Profile.
The HoneywellDecoderSettingsV2.exm file may contain profiles for both Wedge Mode and POS Mode. The
HoneywellDecoderSettingsV2.exm is in XML format and each section element defines a different profile. The profile
targeted for Wedge Mode is identified by the name "HONWedge". There can only be one HONWedge profile. All other
profiles are available for POS applications.
3 - 6
on page 1-13
Connecting