Honeywell Dolphin 75E User Manual page 82

From the Ping screen you can initiate a ping to a specified remote host and see the results. Enter the destination IP
address in the box and then touch Ping. The results appear in the lower half of the screen. You can configure the
parameters of the ping being sent from the Settings screen.
Ping
Note: You do not need to complete all the fields on Settings screen to successfully execute a Ping. Just enter the
Destination IP address on the Ping screen.
Configuring the Ping App
Swipe left to access the Settings screen and then modify one or more of the following fields:
• Timeout
Enter the timeout time in millisecond intervals; 1000 is the default.
• Send buffer size
Indicate the buffer size for sending; 32 is the default.
• Send count
Indicate the count for sending; 4 is the default. Check Infinite to make the send count infinite.
• TTL
Enter the Time To Live (TTL); 1–255. This is the maximum amount of time a packet is allowed to travel through the
network before it is discarded.
• TOS
Enter the Type of Service (TOS); 1–255. This specifies the value in the IP header for Echo request messages sent.
• Rec route for count hops
Enter the number of hops to record in the IP header; 1–9. This field traces the route of the packets for each hop. The
hop count is the number of network devices between the starting node and the destination node that an IP packet hits
while traveling over a network. The number of hops is recorded in the IP header.
• Timestamp route
Enter the number of timestamps to record for each hop; 1–4 The timestamp is the packet's arrival time at each hop.
Check the box next to Don't Fragment to specify echo request messages are sent with the Don't Fragment flag in the
IP header set to 1. The Echo Request message cannot be fragmented by routers in the path to the destination.
6 - 8
Settings