Figure 1-3. Typical Single-width PMC Module Placement on MVME230x
5. Slide the edge connector(s) of the PMC module into the front
6. Insert the two short Phillips screws through the holes at the
7. If installing two single-width PMCs, repeat the above
Primary PMCspan
To install a PMCspan-002 PCI expansion module on your
MVME230x, refer to Figure 1-4 and perform the following steps.
This procedure assumes that you have read the userÕs manual that
panel opening(s) from behind and place the PMC module on
top of the MVME230x. The four connectors on the underside
of the PMC module should then connect smoothly with the
corresponding connectors for a single-width PMC
(J11/J12/J13/J14 or J21/J22/J23/J24, all eight for a double-
width PMC) on the MVME230x.
forward corners of the PMC module, into the standoffs on the
MVME230x. Tighten the screws.
procedure for the second PMC.
Installing the MVME230x Hardware
1
2064 9708
1-15