Mvme230X - Motorola MVME2301 Installation And Use Manual

MVME230 x
Before installing the MVME230x into your VME chassis, ensure that
the jumpers on the MVME230x J15, J16, and J17 headers are
configured, as previously described. This procedure assumes that
you have already installed the PMCspan(s) if desired, and any
PMCs that you have selected.
Proceed as follows to install the MVME230x in the VME chassis:
1. Attach an ESD strap to your wrist. Attach the other end of the
2. Perform an operating system shutdown:
Inserting or removing modules with power applied
!
may result in damage to module components.
Caution
Dangerous voltages, capable of causing death, are
!
present in this equipment. Use extreme caution when
handling, testing, and adjusting.
Warning
3. Remove the filler panel from the card slot where you are
ESD strap to the chassis as a ground. The ESD strap must be
secured to your wrist and to ground throughout the
procedure.
a. Turn the AC or DC power off and remove the AC cord or
DC power lines from the system.
b. Remove chassis or system cover(s) as necessary for access
to the VMEmodules.
going to install the MVME230x. If you have installed one or
more PMCspan PCI expansion modules onto your
MVME230x, you will need to remove filler panels from one
additional card slot for each PMCspan, above the card slot for
the MVME230x.
Installing the MVME230x Hardware
1
1-21