Pmcs; Pmcspan; System Console Terminal; Figure 1-2. General-Purpose Software-Readable Header - Motorola MVME2301 Installation And Use Manual

Preparing and Installing the MVME2300-Series Module
1

Figure 1-2. General-Purpose Software-Readable Header

PMCs

PMCspan

System Console Terminal

1-12
J17
Bit 0 (SRH0) 1
Bit 1 (SRH1)
Bit 2 (SRH2)
Bit 3 (SRH3)
Bit 4 (SRH4)
Bit 5 (SRH5)
Bit 6 (SRH6)
Bit 7 (SRH7) 15
For a discussion of any configurable items on the PMCs, refer to the
userÕs manual for the particular PMCs.
You will need to use an additional slot in the VME chassis for each
PMCspan expansion module you plan to use. Before installing a
PMCspan on the MVME230x, you must install the selected PMCs
on the PMCspan. Refer to the PMCspan PMCAdapter Carrier Module
Instllation and Use manual for instructions.
Ensure that jumpers are installed on all bits on header J17 of the
MVME230x board as shown in Figure 1-2. This is necessary when
the PPCBug firmware is used. Connect the terminal via a cable to
the RJ45 DEBUG connector J2. See Table C-3 for pin signal
assignments. Set up the terminal as follows:
PPCBug INSTALLED
2
Reserved for future use
Setup parameter source (In=Flash; Out=NVRAM)
Reserved for future use
Reserved for future use
Reserved for future use
Reserved for future use
Reserved for future use
16
Reserved for future use