Rotor, Gear Assembly - Makita DHP480 Technical Information

R
epair
[3] DISASSEMBLY/ASSEMBLY

[3] -2. Rotor, Gear assembly

DISASSEMBLING
(1) Remove Drill chuck as drawn in Figs. 1 an 2.
(2) Disassemble Gear assembly as drawn in Fig. 8.
Fig. 8
1. By unscrewing nine 3x16 tapping screws,
remove Housing R from Housing L.
Housing R
Housing L
3. Remove Speed change lever from Gear assembly.
Note: Be careful not to lose Compression spring 4.
4. Separate Gear assembly from Motor section.
Speed
change lever
Motor section
3x16 Tapping screw
(9 pcs.)
Gear
assembly
2. Remove Gear assembly section (Gear assembly,
Change ring, Speed change lever) and Motor
section (Rotor and Stator) from Housing L.
Gear assembly
Change ring
Housing L
5. Put Rotor section on a workbench so that
the drive end of Rotor touches the workbench.
Press Stator down to separate it from Rotor.
Rotor
Stator
P 5/ 12
Speed
change lever
Stator
Rotor
Rotor
Stator