Issuing The Cisco Ios Command Using The Cli; Configuring The Access Point System Power Settings Using A Browser - Cisco Aironet 1130AG Hardware Installation Manual

Chapter 6 Troubleshooting

Issuing the Cisco IOS Command Using the CLI

Follow these steps to issue the Cisco IOS command for your power scenario:
Connect a PC to the access point console port and use a terminal emulator to establish a session with the
Step 1
access point (refer to the
From the privileged EXEC mode (refer to the
Step 2
the command below that applies to your power configuration (see
•
•
Enter the write memory command to save the setting to the access point memory.
Step 3
Enter the quit command to exit the terminal session.
Step 4

Configuring the Access Point System Power Settings Using a Browser

You can also use your browser to set the access point System Power Settings.
The access point web-browser interface is fully compatible with Microsoft Internet Explorer version 6.0
Note
on Windows 98 and 2000 platforms and with Netscape version 7.0 on Windows 98, Windows 2000, and
Solaris platforms.
When using the access point browser interface, you should disable your browser pop-up blocker.
Note
Figure 6-2
Figure 6-2
OL-6226-02
"Connecting to the Access Point Locally" section on page
power inline negotiation injector xxxx.xxxx.xxxx
(where xxxx.xxxx.xxxx is the MAC address of the switch port to which the access point is
connected)
The MAC address might be available from the Inline Power Status message.
Note
power inline negotiation prestandard source
shows the system power setting options and indicates the power status of the access point.
System Power Settings
"Cisco IOS Command Modes" section on page
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
Low Power Condition
3-4).
Table 6-2):
5-2), enter
6-11