Assigning Basic Settings - Cisco Aironet 1130AG Hardware Installation Manual

Chapter 3 Configuring the Access Point for the First Time
Figure 3-1
Figure 3-1
1
Step 3 Set up a terminal emulator on your PC to communicate with the access point. Use the following settings
for the terminal emulator connection: 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.

Assigning Basic Settings

After you determine or assign the access point's IP address, you can browse to the access point's Express
Setup page and perform an initial configuration:
Step 1 Open your Internet browser.
Note
Note
Step 2 Enter the access point's IP address in the browser address line and press Enter. An Enter Network
Password screen appears.
OL-6226-02
shows the console port location.
Console Port Location
1
Console port
The access point web-browser interface is fully compatible with Microsoft Internet Explorer
version 6.0 on Windows 98 and 2000 platforms, and with Netscape version 7.0 on Windows 98,
Windows 2000, and Solaris platforms.
When using the access point browser interface, you should disable your browser pop-up blocker.
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide

Assigning Basic Settings

3-5