Securing The Access Point To The Mounting Plate - Cisco Aironet 1130AG Hardware Installation Manual

Securing the Access Point

Securing the Access Point to the Mounting Plate

The mounting plate provides two methods of securing your access point to restrict its removal:
•
•
Follow these instructions to install the security hasp adapter:
Open the access point cover (see the
Step 1
Carefully tilt the security hasp adapter and insert the access point security hasp tab into the notch on the
Step 2
security hasp adapter (see
Figure 2-12
1
2
Step 3 Push down on the security hasp adapter to expose the padlock post hole.
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
2-18
You can use the security hasp adapter (supplied) and a padlock (that you provide) to secure your
access point to the mounting plate (refer to
Lock models 120T or 121T.
The security hasp adapter covers the cable bay area (including the power port, Ethernet port,
Note
console port, and the mode button) to prevent the installation or removal of the cables or the
activation of the mode button.
You can use the 8 x 32 x 3/16 in. pan head screw (provided) or a tamper-resistant head screw (that
you provide) to attach the access point to the mounting plate using the security screw hole (see
Figure 2-10).
Using a tamper-resistant head screw to secure the access point to the mounting plate does
Note
not prevent someone from inserting or removing the access point cables or pressing the
mode button.
Figure
Installing the Security Hasp Adapter
Access point security hasp tab
Security hasp notch
Figure 1-3 on page
"Opening the Access Point Cover" section on page
2-12).
2
1
3 Security hasp adapter
Chapter 2 Installing the Access Point
1-6). Compatible padlocks are Master
2-9).
3
OL-6226-02