Cisco Aironet 1130AG Hardware Installation Manual page 39

Chapter 2 Installing the Access Point
Drill a 3/16 in. (4.7 mm) hole at the X mounting hole locations you marked.
Step 2
Insert the wall anchors into the mounting holes.
Step 3
If needed, drill or cut a cable access hole (see
Step 4
power cables and pull the cables through the access hole until you have about 1 foot of exposed cables
protruding from the hole.
Note
Position the mounting plate over the wall anchors or the drilled holes.
Step 5
Insert two 8 x 32 x 1 inch pan head screws in the X mounting holes and tighten.
Step 6
To attach the access point to the mounting plate, see
section on page
OL-6226-02
You can optionally insert the Ethernet cable and the power cable (if used) through the cable
access notch in access point housing (see
2-15.
Mounting the Access Point on a Horizontal or Vertical Surface
Figure 2-6) large enough for the Ethernet and possibly the
Figure 2-5).
"Attaching the Access Point to the Mounting Plate"
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
2-11