Using A Telnet Session To Access The Cli - Cisco Aironet 1130AG Hardware Installation Manual

Chapter 3 Configuring the Access Point for the First Time

Using a Telnet Session to Access the CLI

Follow these steps to browse to access the CLI using a Telnet session. These steps are for a PC running
Microsoft Windows with a Telnet terminal application. Check your PC operating instructions for
detailed instructions for your operating system.
Step 1 Choose Start > Programs > Accessories > Telnet.
If Telnet is not listed in your Accessories menu, choose Start > Run, type Telnet in the entry field, and
press Enter.
Step 2 When the Telnet window appears, click Connect and choose Remote System.
Note
In the Host Name field, type the access point's IP address and click Connect.
Step 3
OL-6226-02
In Windows 2000, the Telnet window does not contain drop-down menus. To start the Telnet
session in Windows 2000, type open followed by the access point's IP address.
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide

Using a Telnet Session to Access the CLI

3-15