Cisco Aironet 1130AG Hardware Installation Manual page 96

Low Power Condition
If the access point receives power through PoE, the output current of the power sourcing equipment
Caution
(PSE) cannot exceed 400 mA per port. The power source must comply with IEEE802.3af or IEC60950
for limited power sources.
Table 6-3
power options.
Table 6-3 Access Point System Power Settings and Cisco Switch Commands
Power Source
AC power module
Cisco switch that supports
Intelligent Power Management
Cisco switch that does not
support Intelligent Power
1
Management
2
Power injector used with a
Cisco switch that supports
Intelligent Power Management
2
Power injector used with a
Cisco switch that does not
support Intelligent Power
1
Management
Power injector used with a
non-Cisco switch
802.3af compliant non-Cisco
switches
1. You should check the release notes for your Cisco power source to determine which Cisco IOS release supports Intelligent Power Management. Support
for Intelligent Power Management might not be currently available for your Cisco power source.
2. Power injector must be AIR-PWRINJ3 or AIR-PWRINJ-FIB.
3. Cisco switches that support Intelligent Power Management always configure the use of a power injector at the switch.
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
6-12
lists the access point system power settings and the Cisco switch power commands for several
Access Point System Power Settings
Configuration changes are not required
Power Settings:
1
Power Negotiation (selected)
Power Injector:
Installed on Port with MAC Address (unchecked)
Power Settings:
Pre-standard Compatibility (selected)
Power Injector:
Installed on Port with MAC Address (unchecked)
Power Settings:
Power Negotiation (selected)
1
Power Injector:
Installed on Port with MAC Address (unchecked)
Power Settings:
Power Negotiation (selected)
Power Injector:
Installed on Port with MAC Address (checked)
Configuration changes are not required
Configuration changes are not required
Chapter 6 Troubleshooting
Cisco Switch
Power Command
power inline never
power inline auto
power inline auto
3
power inline never
power inline never
–
–
OL-6226-02