Cisco Aironet 1130AG Hardware Installation Manual page 42

Mounting the Access Point Above a Suspended Ceiling
Follow these steps to mount the access point above a suspended ceiling. Refer to
proceeding.
Figure 2-8
1 Suspended ceiling T-rail
2 T-bar box hanger
3
Bracket mounting clip
Insert the bracket mounting clip's tab into the rectangular hole on the access point mounting bracket.
Step 1
Step 2 Place the clip over the T-bar box hanger (refer to
bracket with the 1/4-20 fastener (supplied with the T-bar hanger).
Figure 2-9
Step 3 Remove a ceiling tile adjacent to the mounting location.
Step 4 Configure the ends of the T-bar box hanger to allow for maximum clearance above the ceiling tile. See
the illustration above.
Step 5 Open the access point cover and connect the Ethernet cable to the access point (see the
an Ethernet Network with an Inline Power Source" section on page
Step 6 Attach the access point to the access point mounting bracket (see the
Mounting Plate" section on page
Step 7 Attach the T-rail clips on the each end of the T-bar box hanger to the ceiling grid T-rails. Make sure the
clips are securely attached to the T-rails.
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
2-14
T-Bar Grid Mounting Bracket Parts
6
1
T-Bar and Mounting Bracket
2-15).
3
4
5
4 Access point mounting bracket
5 Access point
6
T-rail clip
Figure 2-9) and secure it to the access point mounting
Chapter 2 Installing the Access Point
Figure 2-8 before
6
2
1
"Connecting to
2-21).
"Attaching the Access Point to the
OL-6226-02