Toro 07390 Workman HDX-Auto Operator's Manual page 56

inch), repeat steps 3
(1/4 inch) gap between the pedal and the floor.
Adjusting the Accelerator Pedal Upstop
1. With the accelerator pedal up, measure the
distance from the rearward-bottom corner of the
accelerator-pedal arm to the floor
Note: Write down this measurement (measurement
1).
1. Accelerator-pedal arm
2. Measurement 1
2. Gently move the throttle pedal down until the free play
is removed from between the accelerator pedal and the
throttle cable (Figure
3. While holding the pedal in position to remove the free
play, measure the distance from the rearward bottom
corner of the accelerator-pedal arm to the floor
88).
Note: Write down this measurement (measurement
2).
4. Subtract measurement 2 from measurement 1; the
result is the pedal-free travel.
Note: The pedal-free travel should measure 3 mm
(0.125 inch).
5. If the pedal-free travel is larger than or smaller than 3
mm (0.125 inch), perform the following:
A. Loosen the jam nut that secures the
accelerator-pedal stop
B. Rotate the accelerator-pedal stop in the following
directions:
•
Clockwise to increase the pedal-free travel
(Figure 89).
•
Counterclockwise to decrease the pedal-free
travel (Figure
and 4 until you measure a 6.35 mm
(Figure 88).
Figure 88
3. Measurement 2
88).
(Figure 89).
89).
1. Accelerator-pedal stop
2. Jam nut
C. Tighten the jam nut
D. Repeat steps
travel
Note: The pedal-free travel should measure 3
mm (0.125 inch).
E. Repeat steps
travel is 3 mm (0.125 inch).
(Figure
56
Figure 89
3. Flange of the
accelerator-pedal arm
(Figure 89).
1 through 4 to measure the pedal-free
(Figure 89).
A through D until the pedal-free