Adjusting The Brake Pedal - Toro 07390 Workman HDX-Auto Operator's Manual

Adjusting the Brake Pedal

Service Interval: Every 200 hours
1. Remove the hood; refer to
38).
2. Remove the cotter pin and clevis pin securing the
master-cylinder yoke to the brake pedal pivot
81).
1. Cotter pin
2. Brake pedal pivot
3. Clevis pin
3. Lift up on the brake pedal
the frame.
1. Brake pedal
4. Loosen the jam nuts securing the yoke to the master
cylinder shaft (Figure
5. Adjust the yoke until its holes align with the hole in the
brake pedal pivot (Figure
6. Secure the yoke to the pedal pivot with the clevis pin
and cotter pin (Figure
Removing the Hood (page
Figure 81
4. Master-cylinder yoke
5. Jam nut
(Figure 82) until it contacts
Figure 82
2. Accelerator pedal
81).
81).
81).
7. Tighten the jam nut securing the yoke to the master
cylinder shaft
Note: The brake-master cylinder must relieve the
pressure from the service brake when it is properly
adjusted.
8. Install the hood; refer to
(Figure
53
(Figure 81).
Removing the Hood (page 38).